TRIGGER JOB  $120.00-$250.00

INCLUDES SMOOTHING ACTION, REDUCING PULL WEIGHT, NEW SPRINGS, CORRECT TIMING, OVERSIZE HAND IF NECESSARY


SQUARE TO ROUND BUTT CONVERSION  $160.00

DOES NOT INCLUDE NEW GRIPS OR REFINISH IF NECESSARY (S&W ONLY)


BOB HAMMER/HALF-BOB HAMMER  $100.00

INCLUDES DISASSEMBLY, CLEANING & LUBING OF INTERNALS.  wE CAN COMPLETELY REMOVE HAMMER SPUR OR REMOVE HALF OF THE SPUR AND ROUND OVER THE EDGES TO RETAIN SINGLE ACTION CAPABILITY WHILE ALLOWING FOR A LOW-SNAG DRAW.


RE-CONTOUR TRIGGER  $100.00+

INCLUDES REMOVAL OF SERRATIONS, ROUNDING EDGES OF TRIGGER, REDUCE WIDTH OF TRIGGER IF NECESSARY, DISASSEMBLY, CLEANING & LUBING OF INTERNALS.


CHAMFER CHAMBERS  $65.00

BEVELING THE ENTRANCE TO THE CHAMBER TO MAKE INSERTING ROUNDS SMOOTHER.


BALL DETENT LOCK CONVERSION  $100.00

REMOVAL OF THE OLD LOCK AT THE END OF THE EJECTOR ROD ON S&WS AND REPLACES IT WITH A BALL & DETENT THAT LOCKS THE CRANE TO THE FRAME.


LENGTHEN FORCING CONE & TRUE BARREL FACE  $75.00


ADJUST BARREL/CYLINDER GAP  $50.00


STRAIGHTEN CRANE, EJECTOR ROD, & CENTER PIN  $125.00

DOES NOT INCLUDE COST OF NEW PARTS IF NEEDED


REFINISHING



REVOLVER