Custom Revolvers

Here at Hatfields we specialize in the custom carry revolver. These are a few of the most common modifications we do for wheelguns.

We do not charge flat rates, we charge by the hour.   Average costs are listed below,
                            these are not estimates or guarantees, just averages.  


* Trigger Job  $100-$250
            Includes stoning engagements, smoothing action,
            reducing pull wieght, new springs, correct timing,
            oversize hand(if necessary), test-fire  

* Square butt to round butt conversion $160
            Does not include new grips or refinish if necessary.

* Bob Hammer/ Half-Bob Hammer $75
            Includes disassembly, cleaning & lubing of internals. We
            can completely remove hammer spur or remove half of the
            pur and round over the edges to retain single action
            capability while allowing for a low-snag draw.

* Re-contour trigger  $85-$125
            Includes removal of serrations, rounding edges of 
            trigger, reduce width of trigger if necessary, disassembly,
            cleaning & lubing of internals. 

* Barrel Porting $160+